Tronic Compartment PVC Trunking Internal Bend 100mm x 50mm

Our review

This is a PVC internal bend made by Tronic for compartment trunking, sized 100mm by 50mm. It is the fitting you use where a run of compartment trunking turns a corner, and its dividers carry the separation of the straight sections through the bend so power and data cabling do not mix at that point. It suits electricians and contractors working on commercial or industrial installations where cabling is distributed across a facility, rather than someone doing a single small domestic job. Before ordering, confirm the bend matches the profile and dimensions of your existing trunking, and that the divider layout lines up with the compartments you are using, since the bend has to join two lengths cleanly. Compare it with plain non-compartment bends, which are cheaper but let cables converge at corners, and with manufactured bends from other ranges, where a different profile or divider arrangement may not marry up with Tronic trunking. Check the quantity of bends your route needs, as each corner in the run requires one.