Tronic PVC Conduit Bending Spring 20mm

Our review

This Tronic bending spring is a simple hand tool for anyone installing PVC conduit, whether you are an electrician running cable routes or a DIYer tidying up wiring at home. You push it into the conduit at the point where the bend should go, then bend the conduit by hand. Because the spring supports the walls from inside, the pipe is far less likely to kink, flatten or collapse at the curve, which keeps the run neat and makes cable pulling easier later. The 20mm size refers to the nominal conduit diameter it fits, so measure your conduit before ordering, since a spring that is too large will not enter and one that is too small will not support the walls properly. Compare it with other bending methods such as pre-formed bends or a bending machine: a spring is the cheapest and most portable option for occasional bends, while machines suit high-volume work. Also check whether your conduit is rigid or flexible PVC, as the technique differs. It is available on Sokonia.